No time to assemble? Want to get in the air in minimum time? Then this is the one for you. A pre assembled Handy Man – now that's 'handy'

Just add a receiver, ESC and battery and you are Ready to Fly.

Symmetrical aerofoil wings with large control surfaces perform 3D manoeuvres at pilots' command.

Those pilots that are a fan of the TWM Melting will warm to this model as it takes 3D to the next level.

• The Durable foam construction takes care of unintentional touch downs. Although the model is not indestructible – it is more resilient than a balsa airframe.
• The motor has been selected to give optimum performance; the 'Pre-assembled Combo Set' version comes with factory installed Brushless Outrunner Motor 28/30 (KM0283010), Propeller Adaptor (HW2340100) and 4 Micro Servos (SV2031). Some pilots prefer to fit fixed props for improved performance, but the folding prop is good if flying from rough grass.

• 'Pre-assembled Combo Set Version'
• Factory installed 4 micro servos and brushless outrunner motor.
• Code No. : GM039P
• Wing Span : 36.5 in / 930 mm
• Wing Area : 346 sq.in / 22.3 sq.dm
• Flying Weight : 19-23 oz / 540-650 g
• Fuselage Length : 41.5 in / 1055 mm
• Requires : 4-channel radio, 30A brushless ESC, 2 cells 7.4V 15C 1300mAh (Indoor flying) to 3 cells 11.1V 15C 1800mAh (Outdoor flying) Li-Po battery and charge

The manufacturer recommends using epoxy glue to put this kit together. However from our own experience we did not find epoxy the best type of glue for EPO and we recommend a cyano glue such as Bob Smiths Super Gold or Gold Cyno or Multiplex Zacki adhesive. Many standard forms of Cyno adhesives can also be used, but we always advise testing unknown glues on scrap foam before committing them to use.