This is the Ready Assembled Combo Version - for the J10 Kit Only or Combo None Assembled see seperate listings.

The videos below show the J10 flying in various conditions. In one video you will get to see how the J10 handles the wind and in the other videos there's some great general club flying and J10 chases, Warning if you watch the videos you will want one!

Although the manufacturer recommends a 30/35 Amp ESC for this aircraft, we have found that with a good battery the fan will draw in excess of 37 Amps. Following many flights with our own models we would recommend a 40 to 50 amp ESC on a 3 Cell Set Up and if using the 4 Cell Turbo Motor and TWM Fan we recommend a 60 to 70 amp ESC.

As with all final fix motor installations you should check the ESC used is adequate for your individual set up

• The Wings Maker's electric jet series.
• Hot aerobatics at high speed and scaled flying at low speed.
• Light weight and strong EPO foam provides structural strength and rigidity.
• 'Pre-assembled Combo Set Version', comes with factory installed Brushless Outrunner Motor 28/30 (KM0283110), Ducted Fan Unit (PL6800010) and 3 Micro Servos (SV2031).

• Code No. : GE034C
• Wing Span : 28.7 in / 730 mm
• Wing Area : 310 sq in / 20 sq dm
• Flying Weight : 28.5 oz / 805 g
• Fuselage Length : 42.7 in / 1085 mm
• Requires : 4-channel "mixing radio" (elevator and aileron), 40A (burst 50A) brushless ESC and 3 cells 11.1V 20C 2100mAh battery and charger

From our own experience we did not find 5 minute epoxy the best type of glue for EPO and we recommend Bob Smiths Super Gold or Gold Cyno or Multiplex Zacki adhesive. Many standard forms of Cyno adhesives can also be used, but we always advise testing unknown glues on scrap foam before committing them to use.