Overview

BE A CREATOR

Let your fantasy, your imagination and your creativity run wild with Vector Boards.

The new Vector Boards offer you the opportunity to develop and build your own models according to your wishes.

Whether glider, remote-controlled aircraft model, vehicle model or stand model, the Vector Board is very versatile.

Vector Board is more robust and tear-resistant than EPP and it will also be used in future on the Vector Line models.

Application examples are offered by the respective Vector Board strengths.

Go ahead and build your gliding model, download a 3-page view from the internet. Print them out and put them on the Vector Boards. Now just cut it out, add the eventually required trim weight, (can be a small coin), paint and your own hand-launch glider is ready.

Print out the same view enlarged, so that the wing of the model corresponds approximately to the total area of an A4 paper sheet and experiment with the Vector Unit.

Vector Board in thicknesses of 0.2-2 mm is ideal for indoor miniature aeroplane models under 30g. The material can be used to produce wings, fuselages and tail units. Ornaments can be made without problems e.g. for non-structural parts or cockpit parts. It is very well suited to make thermoforming models.

Material surface

We decided to make the Vector Board material as light as possible, since most of it is about flying. Since the Vector Board material is cast in blocks and then divided into the different thicknesses, the surface of the Vector Board may look slightly different depending on the thickness.

The casting creates a kind of ice crystal look with streaks in the surface.

Features

• Light
• Pretty tough
• Finely pored
• Flexible
• Tear-resistant (except for sharp-edged cuts)

Processing:

• The Vector Board can be cut with the cutter, laser, hot wire or a knife or sawed with a fretsaw (fretsaw with a fine blade).
• You can glue the Vector Board with UHU por, hot glue or super-glue.
• You can paint it with felt pens, crayons, acrylic paints, universal paints, watercolours, digital printing.
• If desired, you can also deep-draw the Vector Board to create more elaborate shapes. With the hot air blower, simple shapes can be bent.

Specifications

• Width [mm]: 300
• Thickness [mm]: 6,0
• Weight [g]: 78
• Overall length [mm]: 1000
• Material: Vector Board
• Piece / Pack: 5